Lynx L-210 Manual do Utilizador

Web Interface User’s Guide ADSL Ethernet & USB Combo Router

10 To configure the Lynx L-210 as a bridge, click on Setup and

11 service provider or your ISP will supply these; in this case

12 To complete the connection you must now click the apply butt

13 Figure 6 (PPPOE Connection Setup) To complete the conn

14 Figure 7 (DHCP Connection Setup) To complete the conne

15 Figure 8 (Static IP Connection Setup) To complete

16 Figure 9 (CLIP Connection Setup) To complete the con

17 second DHCP server into the network, you will experience net

18 Figure 11 (Example of a DHCP Relay configuration) By turn

19 Figure 12 (Management IP address) The apply button will

2 1. Introduction ...

20 Figure 13 (Management IP address) The apply

21 Figure 13 (Port Forwarding: Netmeeting) The apply button

22 The apply button will temporarily save this connection. To m

23 through the bridge based on source MAC address, destination

24 ARP frames through the system. The second rule allows all IP

25 4.6.8 Static Routing If the Lynx L-210 is connected to more

26 will only send out RIP information. Selecting both means tha

27 4.7.2 User Management You can change your Lynx L-210’s usern

28 default DHCP configuration, you should be able to Ping the n

29 4.8.3 DHCP Clients Select to view the list of DHCP clients.

3 1. Introduction The Lynx L-210 is the perfect high-speed WAN

30 5. Appendix A: Troubleshooting Below is a list of commonly

31 5.4 The DSL Link LED is always off 1. Make sure you have D

32 6. Lynx L-210 terms What is a firewall? A firewall is pro

33 One of the configuration parameters transmitted to each netw

4 Management Support • Web Based HTTP management GUI • TFTP/F

5 2. Your gateway at a glance The Lynx L-210 may have differe

6 3. Installing your Lynx L-210 1. Locate an optimum location

7 4. Setting up your Lynx L-210 This section will guide you t

8 Figure 2 (Quick Start page) 4.3 Setup (for advance user

9 4.3.1 Wide Area Network connection On the other side of the