Lynx L15ICE Manual Página 1

User Manual / Installation InstructionsOutdoor Ice Machine Part #31966 Rev. 3-06Lynx Professional Grills6023-25 Bandini Blvd., Commerce, CA 90040Se

102. Water Supply and Drain ConnectionsTo prevent damage to the freezer mechanism, do not operate this icemaker when the water supply is OFF, or if th

113. Electrical ConnectionsTHIS APPLIANCE MUST BE GROUNDED.This icemaker requires a ground that meets national and local electrical code requirements.

12D. StartupCheck that shipping tape(s), string and packing are removed before starting the icemaker.1) Clean inside the storage bin and door.2) Open

13III. Cleaning and Maintenance1. Ensure all components, fasteners and thumbscrews are securely in place after any maintenance or cleaning is done to

144) Spread out the tabs on both sides of the water tank to unlock it, then pull it out toward you. Drain the tank.5) After draining, slide in the wa

1512) Move the control switch to the "WASH" position to circulate clean water for about 5 minutes.13) Move the control switch to the "O

167) Spread out the tabs on both sides to unlock the water tank, and pull it out toward you. Soak the water tank in the sanitizing solution for 10 min

1713) Position and lock the ice chute onto the front and rear frame pipes by pushing the chute down until it clicks onto both pipes.14) Slide in the w

18Important Safety Instructions24) Spread out the tabs on both sides of the water tank to unlock it, then pull it out toward you. Drain the tank.25) A

I. Limited One -Year Warranty. Ice Machine shall be free from defects in material and workmanship under normal and proper use and maintenance as spe

2Important Safety InstructionsOnly qualied service technicians should attempt to install, service or maintain this icemaker. No installation, service

Questions? Talk to your Lynx Authorized Dealer or visit our website at www.lynxgrills.comLynx Professional Grills • 6023 E. Bandini Blvd. • Commerce,

3ContentsCONTENTSI. Specications ...

4SpecificationsA. ConstructionTop PanelIce Making MechanismScoop HolderFront PanelControl SwitchLouverBin ControlThermostatSlopeMagnet CatchDoor

5ICE MACHINESpecificationsB. Nameplate RatingSee the nameplate for electrical and refrigeration specications. This nameplate is located on the rear p

6C. Dimensions/Connections

7II. Installation InstructionsA. Checks Before InstallationVisually inspect the exterior of the shipping container and report any severe damage to th

82. Built-in Installation Site 1. Do not let the weight of the counter rest on the icemaker.2. Do not build in the icemaker in a corner where the do

9C. Setup1. General 1. Make sure the unit is completely unpacked and that all shipping cartons, tapes and packing are removed BEFORE operating the u